U605 Hose Coupling

U605 Hose Coupling

Materials:

Body: Body: Brass

Surface: electronic Chromium plated

Bushing: Brass

seals: Buna-N

Features :

Designed for use between the hose and the pipe, or between the hose and other equipments.

U605 provides 360 swivel action.

The full-circle swivel reduces the physical strain of aligning the nozzle with fill-pipe.

100% Factory Tested.

Package:

Product ID Net Weight Cross Weight Dimension

U605-A/B 21kg/case of 100 24kg/case of 100 24x24x38 cm /case of 100

U605-C/D 30kg/case of 100 33kg/case of 100 30x30x40 cm /case of 100

. Examine clearance and replace relevant components when necessary. 1.4. Measurement transducer block 1.5. No discharge due to Solenoid valve closed. First check electric wiring, then trouble on component itself (short circuit of winding or block in valve membrane, etc). 1.6. Pipeline and bottom valve failure If continuously exhaust in vapor separator from beginning, disconnect filter cover and take out filter net; pour same kind of oil in it and given see oil level quickly drop, there is leakage occurred in pipeline and bottom valve. 1.7. No discharge caused by nozzle failure Jam in jointer or filter. Unlock strainer or jointer to remove dirt and waste. Nozzle always in auto-shut state, check automatic shut device, mainly inlet vent, spring. 1.8. Bottom valve be stuck in and pipeline is plugged. Exterior reasons for no delivery Oil level is so lower than bottom valve that pump can’t suck oil. Some valve(s) is closed in pipeline between tank and fuel dispensers. Air goes into valve(s). Single phase valve is rusted in bottom valve. Incorrect installation of flange causes leakage between inlet pipe and fuel dispenser. Inappropriate oil is refueled. Oil is easy to gasify; water in oil freeze; wax in oil plug pipe. Pipe design is unsuitable. Two fuel dispensers, for exa fuel dispenser mple, are connected in same pipeline without valve, or valve can’t shut completely; pipeline has many crooks or too thin. Slow flow rate as starting 3.1. Strainers, including cone-shaped filter net and nozzle filter net, are jammed. 3.2. Large amount of air flow into from broken parts or pipeline, causing much foam in oil indicator. 3.3. Large noise and vibration during operation Vacuum pressure is inadequate. Leakage occurs in overflow valve or pump gasket. Inner leakage in fuel dispenser increase as serious abrasion in pump vane or vane is stuck by waste. Vapor separator trouble Small floater of vapor separator is broken or fall down; insufficient pressure in high pressure chamber as exhausting valve can fuel dispense fuel dispenser r

- -　　 Close - - - 2 -　　 MAJOR ERROR 1 - 1 - 1 - 1　　 MINOR ERROR 1 2 3 100　　 (OTHER) - - - -　　Description: N = No state change. - N = State change to n. - = Not applicable.　　Version 2.01 IFSF - STANDARD FORECOURT PROTOCOL January 2005　　 CONTROLLER DEVICE APPLICATION　　 Page: 9　　2.2 State Event Description　　 THIS SECTION IS THE SAME FOR BOTH CD AND CDP.　　2.2.1 State INOPERATIVE 1　　 STATE DESCRIPTION　　 INOPERATIVE The CD is in the INOPERATIVE state when it is not possible to function. The reason for　　 fuel dispenser this is that essential operational data is missing or a major error has been detected. The CD is　　 also in the INOPERATIVE state after a system boot and after an exit from the SET-UP　　 state.　　 While in the INOPERATIVE state the CD should continuously run a self test to establish if　　 the device is still inoperative or if the device has been configured to allow it to operate.　　 EVENT DESCRIPTION　　 When the CD has been configured with the essential data to operate and no major errors are? fuel dispenser fuel dispenser

nt under joint state authority. Kariuki Kevin Kihara Washington, DC More space for parking SIR �In international events bronze medallists usually get little attention (“A ticket for corruption� August 12th). However, when describing a new corruption ranking based on parking violations by UN diplomats you singled out Chad, the third-highest offender, and ignored Kuwait, the gold winner, which had twice as many infractions. I take solace in finding that my country s diplomats committed zero violations. Manuel Navas Bogotá, Colombia Turkey baiting SIR �Why does The Economist seize the opportunity of a terror attack to take a couple of shots at the Turkish tourist economy (“Resorting to Terror� August 30th)? Terrorism in Turkey has claimed lives, foreign and local, for decades. But Europeans pay attention when bombs go off in tourist resorts such as Marmaris and Bodrum, which are generally overloaded with Britons. I find it difficult to believe that you condone the European attitude of being concerned only when people other than Turks are murdered. You also describe the PKK as fighting for “an independent Kurdish state� a sentiment that all but condones the killing of Turks. To us in Turkey, who nearly every week see victims of terrorism, the killing or fuel dispenser wounding of a few Britons every five years or so won t be bringing us to tears. Yasin Ozturk Istanbul Hot air SIR �In your article (“Going deeper green , September 1st) it was irresponsible to mention China as a big source of emissions without additional clarification. Per person, according to the United Nations Millennium Development Goals Indicators (CDIAC data set), China is less of an offender than the vast majority of countries in the developed world. It hardly seems fair to reprimand the country s 3.19 metric tonnes of carbon dioxide per person, compared with figures of 9.44 for Britons and 19.82 for Americans. Yes, China’s growth is a huge concern and will pose an enormous strain fuel dispenser fuel dispenser